To configure countdown start time and auto-repeat settings

1.While the countdown start time is on the display in the Countdown Timer Mode, hold down A for about three

seconds until the minute setting of the countdown start time starts to flash. This is the setting mode.

• If the countdown start time is not displayed, use the procedure under “To use the countdown timer” (page E-37) to display it.

2. Press Cto move the flashing in the sequence shown below, and select the setting you want to change.

Start time (minutes)

Start Time

 

C

 

Auto-Repeat

(Minutes)

 

 

 

On/Off

 

 

 

 

3.Perform the following operations, depending on which setting currently is selected on the display.

•While the start time setting is flashing, use D(+) and B(–) to change it.

•While the auto-repeat on/off setting (0N or 0FF) is flashing on the display, press Dto toggle auto-repeat on (0N) and off (0FF).

E-38