Basic Operations

Using Tone Effects

Reverb: Makes your notes resonate

Chorus: Adds more breadth to your notes

1Press the REVERB/CHORUS button to cycle through the effect settings as shown below.

•You can find out the current effect setting by looking at the REVERB and CHORUS indicators.

Reverb on

Chorus on

Both on

Both off

2After turning on the effect you want, use the number buttons or the [+]/[–] buttons to select the effect type you want.

•Note that you need to select an effect type with the number buttons or the [+]/[–] buttons within a few seconds after turning on an effect. If you don’t, the display will exit the setting screen.

Effect List

Reverb

1: Room 1

 

 

 

2: Room 2

 

 

3: Hall 1

 

 

4: Hall 2

 

Chorus

1: Chorus 1

 

 

2: Chorus 2

 

 

3: Chorus 3

 

 

4: Chorus 4

PIANO SETTING Button

Pressing this button changes the setup of the keyboard to optimize it for piano play.

Settings

Tone Number: “001”

Rhythm Number: “101”

Layer: Off

Split: Off

Reverb: On (Type 3)

Chorus: Off

Transpose: 00

Touch Response:

Off: Returns to initial default

On: No change

Assignable Jack: SUS

Local Control: On

To optimize keyboard settings for piano play

1Set the MODE switch to NORMAL.2Press the PIANO SETTING button.3Now try playing something on the keyboard.

•The notes you play will sound with a piano tone.

•If you want to play with rhythm accompaniment, press the START/STOP button. This causes a rhythm that is optimized for piano will start to play.

•To stop rhythm play, press the START/STOP button again.

NOTE

•Pressing the PIANO SETTING button while a rhythm is playing stops rhythm play and then changes the keyboard setup.

•The setup of the keyboard does not change if you press the PIANO SETTING button when any one of the following exists.

•During real-time recording of the Song Memory

•During demo tune play

E-21