.To shoot using Move In CS

1.Compose the image at a location where you expect the subject to enter the boundary on the monitor screen.

2.Half-press the shutter button.

•The camera will adjust exposure and focus automatically.

•In this case, use of manual focus (page 46) to preset a fixed focus is recommended.

3.When the boundary on the monitor screen turns green, press the shutter button the rest of the

way down.

At this time the camera will go into recording standby and start pre-recording images and storing them in a buffer, in accordance with the Prerecord Time setting you configured in step 10 under “To setup the camera”

on page 71. After the buffer becomes full, new images Boundary keep being added while older images are continually

being deleted.

The camera will start saving images to memory automatically the moment it detects the subject has moved into the area within the boundary.

•“0 AUTO” flashes on the monitor screen during recording standby and auto recording.

4.Image recording will continue until the end of the Prerecord Time is reached.

•While the camera is in Move In CS recording standby, you can cancel standby by pressing the shutter button all the way down. You then will be able to shoot images normally.

•To stop an ongoing image recording operation, press [SET].

5.Save the CS images (page 53).

B

74

Using BEST SHOT