BASIC IMAGE RECORDING
Changing the Flash Intensity Setting
Perform the following steps to change the flash intensity setting.
1.In a REC mode, press [MENU].
2.Use [] and [] to select the “REC” tab.
3.Use [] and [] to select “Flash Intensity”, and then press [].
4.Use [] and [] to select the setting you want, and then press [SET].
To make flash intensity: | Select this setting: |
Stronger+2
+1
Normal0
Weaker–2
IMPORTANT! 
•Flash intensity may not change if the subject is too far or too close to the camera.
Using Flash Assist
Recording a subject that is outside the flash range can cause the subject to appear dark in the resulting image, because not enough of the flash reaches the subject. When this happens, you can use flash assist to correct the brightness of the recorded subject, so it appears as if the flash illumination was sufficient.
dispdisp
Flash assist used | Flash assist not used |
1.In a REC mode, press [MENU].
2.Use [] and [] to select the “REC” tab.
3.Use [] and [] to select “Flash Assist”, and then press [].
61