10-5-2

Data Communications Precautions

1(YES) ... {replaces the receiving unit’s existing data with the new data}

6(NO) ... {skips to next data item}

*2 With password check: If a file is password protected, a message appears asking for input of the password.

Name of password protected file

Password input field

After inputting the password, press w.

Note the following precautions whenever you perform data communications.

An error occurs whenever you try to send data to a receiving unit that is not yet standing by to receive data. When this happens, press ito clear the error and try again, after setting up the receiving unit to receive data.

An error occurs whenever the receiving unit does not receive any data approximately six minutes after it is set up to receive data. When this happens, press ito clear the error.

An error occurs during data communications if the cable becomes disconnected, if the parameters of the two units do not match, or if any other communications problem occurs. When this happens, press ito clear the error and correct the problem before trying data communications again. If data communications are interrupted by ikey operation or an error, any data successfully received up the interruption will be in the memory of the receiving unit.

An error occurs if the receiving unit memory becomes full during data communications. When this happens, press ito clear the error and delete unneeded data from the receiving unit to make room for the new data, and then try again.

19990401