
Error Messages
7. Error Messages
Attempting to perform some inappropriate operation in the Geometry Mode will cause one of the error messages described below to appear. Use this table as a reference to fi nd out what you need to do when an error message appears.
When you see | It means this: | So you need to do this: | |
this message: | |||
|
| ||
|
|
| |
First select a | You are attempting to construct a | Select the required object(s) and | |
segment. | perpendicular bisector without fi rst | then try again. | |
| selecting a line segment. |
| |
|
|
| |
First select a | You are attempting to construct a |
| |
line and point. | perpendicular or parallel without |
| |
| fi rst selecting a line segment and |
| |
| point. |
| |
|
|
| |
First select | You are trying to construct a |
| |
2 points or a | midpoint without fi rst selecting two |
| |
segment. | points or a line segment. |
| |
|
|
| |
First select | • You are trying to construct a |
| |
the applicable | point of intersection without fi rst |
| |
fi gure. | selecting two lines. |
| |
| • You are trying to execute an Add |
| |
| Animation or Replace Animation |
| |
| command without fi rst selecting |
| |
| the required object. |
| |
| • You are trying to execute an Add |
| |
| Table command without fi rst |
| |
| selecting the required object. |
| |
|
|
| |
First select 2 | You are trying to construct |
| |
segments. | an angle bisector without fi rst |
| |
| selecting two line segments. |
| |
|
|
| |
Too Many | Work memory became full. | Delete objects you no longer need | |
Objects! Work |
| or open a new fi le. | |
memory cleared. |
|
| |
|
|
| |
Invalid | You are attempting to use the | Check to make sure that the | |
Measurement | Expression command to input | expression you are inputting | |
| an expression that contains a | contains only measurements that | |
| measurement that does not exist. | are currently on the screen. | |
|
|
|
20060601