Performing a Full Reset (Initialization)

Performing a full reset initializes memory. This means that all data stored in the memory (RAM) is deleted and all the settings are returned to their initial factory defaults.

Perform a full reset whenever any one of the following conditions exists.

When you want to delete all memory contents and return the settings to their initial factory defaults.

When you are no longer able to use the Handheld Terminal because you forgot your password.

When the Handheld Terminal does not operate normally due to a memory problem.

When the message “A problem with memory contents has been found. ...” appears.

To perform a full reset

Important!

Performing a full reset deletes all data currently stored in the memory (RAM). If possible, backup data of the Handheld Terminal to a computer, Flash Memory, a memory card, or some other medium before performing a full reset.

1.Hold down the power key and push down the reset switch for about one second, until the message shown below appears on the display.

To cancel the full reset operation, press the CLR key.

Memory All Clear Warning

Proceeding with this operation initializes memory.

Press [Trigger key] to proceed

or [CLR key] to cancel.

Trigger key

2. Press the Trigger key. This causes the message shown below to appear.

To cancel the full reset operation, press the CLR key.

Memory All Clear Warning

 

Proceeding with this operation deletes all data

Trigger

stored in memory.

key

Press [Trigger key] to proceed

 

or [CLR key] to cancel.

 

3. Press the Trigger key again.

Full reset is performed, all data in the memory (RAM) are erased and the start-up screen is displayed.

E-33

Page 35
Image 35
Casio IT-500 manual Performing a Full Reset Initialization, To perform a full reset