Chapter 11 Data Communication

Notes

•The above procedures can be used to send or receive all data in specific modes only. You cannot send or receive individual data items.

•Data communication can be interrupted at any time by pressing Esc.

•If the secret memory area is accessed on a unit receiving data, the received data is stored in the secret memory area, regardless of the memory area the data is in on the sending unit.

•Transferring data from the PV-S460/PV-S660 to a PV-100 or PV-200 causes all euro symbols to be replaced by spaces.

•The size of the PV-S460/PV-S660 screen is 160 ⋅ 160 dots. Transferring

PV-S460/PV-S660 Quick-Memo data to a PV-100 or PV-200, which both have 98(V) ⋅ 124(H)-dot screens, causes the right side and bottom part of the Quick-Memo image to be cut off in order to fit the PV-100/ PV-200 screen.

Data Communications Between a PV Unit and a BN Unit

This section describes how to set up and communicate between a PV Unit and a BN Unit (BN-10/BN-20 or BN-10A/BN-20A/BN-40A).

•You must purchase a separately available SB-90 in order to connect a PV Unit to a BN Unit.

To connect a PV Unit to a BN Unit

1.Make sure that the power of both units is turned off.

2.Open the cover of the Mini Cradle port of the BN Unit, and connect its Mini Cradle to the port.

3.Plug the cable that comes with the PV Unit into its cable connector.

124