Casio PX410R, PX575R Edit Standby, step recording, Level Meter Contents During Record, Track Contents After Step Recording, To record to Tracks 2 through 6 using, E-56)

Use the number buttons to input the length of the note or rest (page E-56).

Song Memory Function

	To record to Tracks 2 through 6 using				NOTE
	step recording				• Use the procedure under “Correcting Mistakes While
This procedure describes how to input notes one-by-one,						Step Recording” on page E-59 to correct input mistakes
						you make during step recording.
specifying each note’s pitch and length.
					•	You can add on to a track that already contains recorded
1 Press the SONG MEMORY button three times to						data by selecting that track in step 2 of the above
						procedure. Doing so automatically locates the step
	enter real-time record standby,			and then use the
						recording start point at the first beat immediately
	number buttons to select a song number (0 to 4).					following the previously recorded data.
	• The song number you select should be the one where				•	Whenever you are recording to Tracks 2 through 6, the
		you previously input Track 1.				entire keyboard functions as a melody keyboard,
						regardless of the current MODE button setting.
					•	When playing back data recorded with Advanced Tones
		S g 1 S t e p		R e c
						at the beginning of multiple tracks, the digital piano uses
						the DSP type of the Advanced Tone that is recorded in
2 Use the SONG MEMORY TRACK buttons to select						the track with the largest track number.
					•	When playing back a track that was recorded with an
	the track you want to record to (2 through 6).					Advanced Tone selected, they may be a slight delay
						before the first note of the track sounds. If this happens,
	Example: Select Track 2.
						try to insert a very short rest at the beginning of the
			Flash			track.
						Track Contents After Step Recording
3 Specify a tone number.					In addition to notes and rests, the following data is also
	• Pressing a TONE button or the DRAWBAR ORGAN				recorded to the track during step recording. This data is
					applied whenever the track is played back.
		button displays the tone number and name on the
		display. You can then use the number buttons, or the			• Tone number
		[+] (increase) and [–] (decrease) buttons to change the
		tone.
	• After changing the tone number, press any keyboard					Level Meter Contents During Record/
		key to clear the tone number and name screen, and				Edit Standby
		return to the note input screen.

4 Use the keyboard keys to input notes, or the [0]	Channels 11 through 16 correspond to Tracks 1 through 6.
	Whenever the digital piano is in record or edit (page E-60)
button to input rests.	standby, the level meter display shows which tracks already
	contain recorded data and which are still empty. Tracks with
• At this time, the display shows the keyboard pressure
	four lit segments already contained recorded data, while
(velocity). Use the [+] (increase) and [–] (decrease)
	tracks with one lit segment are not yet recorded.
buttons to change the velocity.
• You can also input a chord.

5

Recorded track

Not recorded track

6Repeat steps 4 and 5 to input more notes.7Press the START/STOP button to end recording when you are finished.

E-58