Assembling the Stand
Unpacking
Getting Ready
•Before starting assembly, check to make sure that you have all the parts shown below. You can find the screws in a plastic bag inside of the polystyrene foam packing material.
•This stand does not include any of the tools required for assembly. It is up to you to prepare a large Philips head
(+) screwdriver for assembly.
B Side panel
c Speaker box
ASide panel
| D Screw 4 |
| E Screw cap |
| (Brown) 4 |
| F Pedal unit 1 |
| I Bracket 2 |
G Screw 2 | J Screw cap |
| |
| (Black) 2 |
H Clip 2 | K Butterfly bolt 2 |
•Before starting assembly of the stand, divide the polystyrene foam packing material into four parts.
Assembling the Stand
CAUTION
•This stand should be assembled by two people working together.
•The stand should be assembled on a flat surface.
•Do not remove the tape securing the keyboard cover in place until assembly is complete. Removing the tape can cause the keyboard cover to open and close during assembly, creating the risk of personal injury to your hands and fingers.
•Take care that you do not pinch your fingers between parts when assembling them.
•When placing the digital piano unit on the floor, be sure to place it on something soft (a blanket, cushion, etc.). Do not place the digital piano directly onto the floor.
When assembling the stand and speaker box C, lay the stand down so it is on its side.
Getting Ready
•Use the four pieces of polystyrene foam to secure side panels A and B in place. You will have an easier time assembling the stand if you raise the side panels up off the ground as shown in the illustration.
•If you do not have any packing material available, use a magazine or some other thick item.
B
A
C Foam
| Foam |
1 | Attach side panels Aand Bto the speaker |
| box C. Secure the side panels using four |
screws D.
•Align the holes in speaker box Cwith the holes in the side panels, and secure them together using the screws D.
•Partially tighten the screws on one side of the speaker box C and then tighten the screws on the other side completely.
•Next, fully tighten the screws that you partially tightened.
B
D
A
C
| D |
| * You can also install the speaker box so it faces |
| outwards towards the back. |
2 | After ensuring that all of the screws are fully |
| tightened, remove the packing material and |
stand up the stand.