Casio QV-10 B, QV-10A, QV-11, QV 10 B Playing Back Images, Displaying Images on a TV Screen, Notes, Notes, Important, Important, to view is displayed, 2. Turn on the camera

Playing Back Images	Playing Back Images	Operation
This section describes how to recall and view images stored in cam-		3. Scroll through the memory pages until the image you want
era memory.
		to view is displayed.
Displaying Images on the Camera’s LCD		• Press [+] to display the next memory page or [–] to display
The QV-10 can store up to 96 images in memory. Images are se-		the previous memory page.
quentially numbered from 1 through 96. Think of camera memory like
a 96-page album of the images you record.
The following procedure describes how to display images on the
camera’s built-in LCD.
1. Enter the Playback Mode.

•Slide the function switch to the

PLAY position.	Notes
2. Turn on the camera.	• If you set the function switch to PLAY after recording an image, that
• Slide the POWER switch in the di-	image appears on the LCD first.
	• The message “MEMORY EMPTY” appears on the LCD if there are
rection indicated by the arrow.
	no images stored in memory when you enter the Playback Mode.
The POWER switch automatically
slides back to its original position
when you release it.

•When power comes on, the page

that was displayed when you last turned power off appears on the LCD.

•You can perform steps 1 and 2 in either order (1 then 2, or 2 then 1).

4950

Playing Back Images Operation

Displaying Images on a TV Screen		Displaying the Memory Page Number
Use the special video cable that comes with the camera to connect		The memory page number is a value in the upper right corner of the
the QV-10 to a television as illustrated below, and you can then view		LCD that indicates the number of the currently shown memory page.
the images stored in camera memory on the TV’s screen.		1. Enter the Playback Mode.
Important!		• Set the function switch to the
•	The camera can be connected only to a TV that is equipped with a	PLAY position.
	VIDEO IN terminal.	2. Press the DISP button.
•	Make sure that the power of both the camera and the TV are turned
	off when making connections.
	Accessory video cable	VIDEO OUT terminal
	TV	• The memory page number ap-
		pears in the upper right corner of
	INPUT	the LCD.

LR VIDEO AUDIO

		•	To clear the memory page num-
VIDEO IN terminal			ber from the LCD, press the DISP
			button again.
After connecting the camera and TV, set the
channel of the TV to the channel used for video
input.
After connecting the camera and TV, use the same procedures as	Notes
	•	The letter “P” next to the memory page number indicates that page
those described under “Displaying Images on the Camera’s LCD” on
page 49.		is “protected” and cannot be deleted. See page 67 for details about
		protecting memory pages.
Important!	•	Note that turning display of the memory page number on and off in
• Note that only images already stored in camera memory can be		the Playback Mode also affects the display of the image number in
viewed on the TV screen. If you change to the camera’s Record		the Record Mode (page 43), and the zoom area indicator used in
Mode, the image picked up by the camera’s lens will not appear on		the zoom operation (page 58).
the TV screen.
51	52