General Precautions

 

LiquidOtherC ystalPrecautionsDigital Camera QV-10

 

• Physical damage and malfunction of this unit can cause the image

MEMORY ERROR message

 

 

data stored in its memory to be deleted. Be sure to always keep

The following error appears on

the built-in monitor whenever

the

backup copies of data by recording them on video tape or by trans-

camera’s flash memory becomes disabled due to malfunction or im-

 

ferring them to personal computer memory.

 

proper operation.

 

 

 

 

 

• Never open the battery compartment cover, disconnect the AC

 

 

 

 

adaptor from the camera or unplug it from the wall socket while the

 

 

 

 

“WAIT” message is on the LCD. Doing so will not only make storage

 

 

 

 

of the current image impossible, it can also corrupt other image data

 

 

 

 

already stored in camera memory.

 

 

 

 

 

Whenever this happens, all of the digital images stored in the

 

camera’s memory will be lost. You will not be able to view stored

 

images or record new ones. Take your camera to your dealer or an

 

 

authorized CASIO service provider as soon as possible after the

 

MEMORY ERROR message appears.

 

 

Operating conditions

 

 

 

• This camera is designed for use in temperatures ranging from 0

° C

 

 

to 40 ° C (32 ° F to 104

° F).

 

• Do not use or keep the camera in the following areas.

— In areas subject to direct sunlight

— In areas subject to high humidity or dust

— Near air conditioners, heaters, or other areas subject to temperature extremes

— Inside of a closed vehicle, especially one parked in the sun

— In areas subject to strong vibration

9 10

Other Precautions

Liquid Crystal Digital Camera QV-10

 

 

 

Condensation

GUIDELINES LAID DOWN BY FCC RULES FOR USE OF

•

When you bring the camera indoors on a cold day or otherwise ex-

THIS UNIT IN THE U.S.A. (not applicable to other areas).

 

 

 

 

pose it to a sudden change of temperature, there is the possibility

 

 

 

 

 

NOTICE

 

 

that condensation can form on the exterior or on interior compo-

 

 

 

nents. Condensation can cause malfunction of the camera, so you

 

This equipment has been tested and found to comply with the lim-

 

should avoid exposing it to conditions that might cause condensa-

 

its for a Class B digital device, pursuant to Part 15 of the FCC

 

tion.

 

Rules. These limits are designed to provide reasonable protection

•

To keep condensation from forming, place the camera into a plastic

 

against

harmful interference in a residential installation. This

 

equipment generates, uses and can radiate radio frequency en-

 

bag before moving it into a location that is much warmer or colder

 

 

 

ergy and, if not installed and used in accordance with the instruc-

 

than your current location. Leave it in the plastic bag until the air

 

 

 

tions, may cause harmful interference to radio communications.

 

inside the bag has a chance to reach the same temperature as the

 

 

 

However, there is no guarantee that interference will not occur in a

 

new location. If condensation does form, remove the batteries from

 

 

 

particular installation. If this equipment does cause harmful inter-

 

the camera and leave the battery compartment cover open for a few

 

 

 

ference to radio or television reception, which can be determined

 

hours.

 

 

 

by turning the equipment off and on, the user is encouraged to try

 

 

 

 

 

 

to correct the interference by one or more of the following mea-

 

 

 

sures:

 

 

 

 

 

 

 

This device complies with Part 15 of the FCC Rules. Operation is

 

 

subject to the following two conditions: (1) this device may not cause

 

 

harmful interference, and (2) this device must accept any interference

 

 

received, including interference that may cause undesired operation.

 

 

• Reorient or relocate the receiving antenna.

 

 

• Increase the separation between the equipment and receiver.

 

 

• Connect the equipment into an outlet on a circuit different from that

 

 

 

to which the receiver is connected.

 

 

• Consult the dealer or an experienced radio/TV technician for help.

 

 

Caution :

Changes or modification to the product not expressly ap-

 

 

proved by CASIO could void the user's authority to operate the prod-

 

 

uct.

 

 

 

Properly shielded cables with ferrite core must be used for connec-

 

 

tion to computer in order to meet FCC emission limits.

 

11

12