Casio WK-3300, WK-3800, WK8000 DS P, DSP L e v e l, DS P P a n, Effect Parameters, DSP Part Parameters

Mixer Function

Effect Parameters			■ DSP System Reverb Send (Range: 000 to 127)
			This parameter adjusts how much reverb is applied to the
The Mixer lets you control the effects applied to each
			DSP part.
individual part, making it different from the Effect Mode,
whose settings are applied to all parts in general.
					D . R v b S n d
■ Reverb Send (Range: 000 to 127)
This parameter controls how much reverb is applied to a part.			■ DSP System Chorus Send (Range: 000 to 127)
A setting of “000” turns reverb off, while a setting of 127
applies maximum reverb.			This parameter adjusts how much chorus is applied to the
• “Reverb Send” does not work with some drum sounds.			DSP part.
	R v b S e n d				D . C h o S n d
■ Chorus Send (Range: 000 to 127)			NOTE
This parameter controls how much chorus send is applied to
			•	Changing the tone, volume, pan pot, coarse tune, fine
a part. A setting “000” turns chorus send off, while a setting				tune, reverb send, or chorus send setting causes the
of 127 applies maximum chorus send.				corresponding MIDI message to be output from the USB
• “Chorus Send” does not work with drum sounds.				port.
			•	Changing the tone settings changes the tone, octave
	C h o	S e n d		shift, reverb send, chorus send, and DSP line* parameter
				settings.
				* When DSP is off (See the NOTE on page E-29).
■ DSP Line (Settings: on, oFF)			•	Turning on the Mixer’s DSP Line parameter (on this
				page) causes the settings of the DSP Pan, DSP System
You can use this parameter to turn DSP line off for a particular
				Reverb Send, and DSP System Chorus parameters to
channel, or to turn it on.				be used in place of the Pan Pot, Reverb Send, and
				Chorus Send parameters.
	DS P	L i n e

DSP Part Parameters

■DSP Level (Range: 0 to 127)

Sets the post-DSP volume.

DSP L e v e l

■DSP Pan (Range: –64 to 0 to 63)

Sets the post-DSP stereo pan.

DS P P a n

E-43