To turn password protection on and off

1 Display the Power On Password setting screen by performing steps 1 through 5 of the procedure under “To change the password” on page 20.

zAt this time, make sure that “Power On Password” is selected on the Power On Password setting screen.

2 Use the [W] and [X] keys to select “On” or “Off”.

z Changing the power on password setting from “Off” to “On” causes the confirmation dialog box shown below to appear.

Press the [ENTER] key to confirm that you want to turn on power on password protection, or [ESC] to exit the dialog box without doing anything.

3 After you are finished, press the [MENU] key to exit the setup menu.

Entering the Password when Turning On the Projector

Turning on the projector while password protection is enabled will cause a password input dialog box to appear on the projection screen. All projector operations will be accessible to you after you input the correct password and press the [ENTER] key.

Note

You can perform the projection size adjustment operation ([ZOOM +] / [ZOOM –] keys), focus operation ([FOCUS S] / [FOCUS T] keys), and power off operation ([ ] key) while the password input dialog box is on the projection screen.

21