Indicator/Error Message

Description and Required Action

POWER

: Amber flashing

The projector was turned off automatically because the lamp turned

 

Red steady

off or did not turn on. After confirming that the POWER/STANDBY

TEMP

: Red flashing

indicator is lit red (without flashing), unplug the power cord. Wait for

 

(0.5-second interval)

a short while and then plug it back in and turn on the projector

LAMP

: Red flashing

again.

 

(0.5-second interval)

If the error occurs again when you turn power back on, wait until

Message

: –

the projector cools down and then replace the lamp (page 37).

 

 

If the lamp does not light after you replace it, contact your retailer

 

 

or nearest authorized CASIO Service Center.

 

 

 

POWER

: Amber flashing

Power has turned off automatically due to a projector memory error.

 

Red steady

Confirm that the POWER/STANDBY indicator is lit red (without

TEMP

: Red flashing

flashing). After checking the POWER/STANDBY indicator, disconnect

 

(2-second interval)

the power cord from the projector and wait for all of the projector’s

LAMP

: Not lit or red flashing

indicators to go out. Next, reconnect the power cord and turn

Message

: –

projector power back on.

 

 

If the error occurs again when you turn power back on, contact your

 

 

retailer or nearest authorized CASIO Service Center.

POWER

: Amber flashing

Power has turned off automatically because the lamp cover is open.

 

Red steady

Perform the following steps.

TEMP

: Amber flashing

1 After confirming that the POWER/STANDBY indicator is lit red

 

(1-second interval)

(without flashing), disconnect the power cord from the projector.

LAMP

: –

2 Check to make sure that the lamp cover is closed.

Message

: –

3 Plug the power cord back in and turn the projector back on again.

 

 

If the error occurs again when you turn power back on, contact your

 

 

retailer or nearest authorized CASIO Service Center.

POWER

: Green steady

It is time to replace the lamp. Replace the lamp following the steps

TEMP

: –

under “Replacing the Lamp” (page 37). Press the [ESC] key to clear

LAMP

: Red flashing

the warning message.

 

(1-second interval)

 

Message

: It is time to replace the

 

 

lamp. Use the

 

 

procedure in the User’s

 

 

Guide to replace the

 

 

lamp as soon as

 

 

possible.

 

POWER

: Amber flashing

The allowable life for the lamp has been exceeded, and the projector

 

Red steady

will not turn on. Replace the lamp following the steps under

TEMP

: –

“Replacing the Lamp” (page 37).

LAMP

: Red steady

 

Message

: The lamp has exceeded

 

 

its service life! The

 

 

projector will not turn

 

 

on until you replace the

 

 

lamp.

 

 

 

 

44