— 117 —
[Caution] For (1):
• This command ends with a NUL code.
• For UPC-A or UPC-E, the bar code is printed when 12 bytes of
bar code data have been entered, and the subsequent data is
handled as normal data.
• For JAN13, the bar code is printed when 13 bytes of bar code
data have been entered, and the subsequent data is handled
as normal data.
• For JAN8, the bar code is printed when 8 bytes of bar code
data have been entered, and the subsequent data is handled
as normal data.
•The data of ITF bar code must have an even number of
columns. Should the data have an odd number of columns,
the last column is ignored.
For (2):
• Numeral “n” indicates the number of data items, and the
subsequent “n” bytes of data are handled as bar code data.
• If “n” is out of the range, the processing of the command is
aborted, and the subsequent data is handled as normal data.
For STANDARD MODE:
• If “d” is out of the range, only a paper feed is executed, and
the subsequent data is handled as normal data.
• If the bar code is wider than the print area for one line, the bar
code is not printed, but only a paper feed is executed.
• The amount of paper feed corresponds to the height of the
bar code (Including the HRI characters if HRI character printing
is specified), irrespective of the line feed width set by a
command such as ESC 2 or ESC 3.
• This command only works if no data exists in the print buffer.
If any data exists in the print buffer, the data subsequent to
“m” is handled as normal data.
• After the bar code is printed, the beginning of the line is taken
as the start position for the next print.
• This command is not affected by any print modes (Emphasis,
double strike, underline, and character size), except for the
inverted character mode.