CDA HCG 730, HCG 740 installation instructions Technical Information For The Installer

TECHNICAL INFORMATION FOR THE INSTALLER

In order to install the cooktop into the kitchen fixture, a hole with the dimen- sions shown in fig. 13 has to be made, bearing in mind the following:

✓within the unit, between the bottom of the cooktop and the upper sur- face of a shelf there must be a clear- ance of at least 30 mm.

It is absolutely essential that you place a separator between the base of the cooktop and the built-in unit or the oven;

✓the cooktop must be kept no less than 200 mm away from any side wall (fig. 13).

✓the hob must be installed at least 60 mm from the wall.

✓there must be a dis-

tance of at least
650 mm between
the hob and any
wall cupboard or
extractor hood posi-
tioned immediately	200
above (see fig. 12).

✓if the hob is installed over a built-in oven, there must be a distance of at least 30 mm between the two appli- ances. The two appliances should be connected to the gas supply with independent connections.

INSTALLATION IN KITCHEN CABINET WITH DOOR (fig. 14)

It is recommended that a 30 mm clear- ance be left between the cooktop and the fixture surface (fig. 14)

Figure 12

450 mm 650 mm

		Figure 13
500		68		0
					60
					0
					2
			0		–
		8
560		4
		0
	–2

Figure 14

Clearance	mm
	30
Door
Space for
connections
	17