Introduction

Congratulations on your purchase of this CDA cooker which has been carefully designed and produced to give you many years of satisfactory use.

Before using this appliance it is essential that the following instructions are carefully read and fully understood.

We would emphasise that the installation section must be fully complied with for your safety to ensure that you obtain the maximum benefits from your appliance.

B

Assembling the backguard

Remove the two spacers “A” and the screw “B” from the rear of the cook- top.

Assemble the backguard as shown in figure 1 and

A

fix it by screwing the cen-

tral screw “B” and the

 

 

spacers “A”.

Fig. 1

Declaration of CE conformity

This cooker has been designed, constructed and marketed in compliance with:

-Safety requirements of EU Directive "Gas" 90/396/EEC;

-Safety requirements of EU Directive "Low Voltage" 2006/95/EC;

-Protection requirements of EU Directive "EMC" 2004/108/EC;

- Requirements of EU Directive 93/68/EEC.

 

GB

4

Page 4
Image 4
CDA RC9321 manual Introduction, Assembling the backguard