7 ROGRAMMING REMOTE CONTROLS
WARNING
A moving door can cause serious injury or death.
1.Keep people clear of opening while door is moving.
2.Do NOT allow children to play with opener, including wall button, remote control, or Wireless Keypad.
3.During programming, the door opener could begin to run, so keep people and objects away from the moving door and its parts. To keep the door from moving, close the door and disconnect it from the Opener by pulling the Emergency Release.
NOTE: For remote control locate Box 3.
1a. Single Button Remote Programming.
NOTE: This opener can learn up to 7 transmitter buttons.
LEARN
•Locate “Learn Code” CODE button and indicator LED on the power head (Fig.
Press and release “Learn Code” button.
–Indicator LED will blink RED at a rate of twice per second.
Within 30 seconds, push remote control button once.
–Indicator LED will stop blinking and stay ON.
Press remote control button again.
–Red LED will go out. Remote is now programmed and ready for use.
Press remote control button again, door will move.
1b. Multi Button Remote Programming.
NOTE: Each button on a
NOTE: Pushing two buttons on power head simultaneously will erase programmed memory and limits must be reset.
For each button.
–Program each button separately using the Single Button Remote Programming steps.
2.Operating.
•Press remote button once.
–Door will move.
Press button again.
–Door will stop.
Press button again.
–Door will move in opposite direction.
NOTE: The door will stop automatically at the fully open or fully closed position.
LOST OR STOLEN REMOTE
1.Clear memory.
Press and hold learn code button (on power head) for 10 seconds or until the red blinking indicator LED goes out.
Program remaining or new remote controls as done previously. Your door opener will no longer recognize any signal received from the missing remote control, or any other which has not been reprogrammed.
NOTE: To program a
Homelink® and Car2U®
device follow the Homelink® or Car2U® instructions in your car owner’s manual.
FCC and IC CERTIFIED
This device complies with FCC Part 15 and RSS 210 of Industry Canada. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which may be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:
Increase the separation between the opener and receiver.
Connect the opener into an outlet on a circuit different from that to which the receiver is connected.
Consult your local dealer.
Limit controls location on power head.
LED | Open | Open |
| ||
Indicator Light | Set Limit | Up Force | |||
Travel Limit | |||||
|
| Button | OPEN Control | ||
|
|
| |||
|
|
|
| Adjustment | |
To |
|
| SET |
| |
Garage Door |
|
|
| ||
|
|
|
| ||
| LEARN MANUAL LIMIT | FORCE | |||
|
|
| SET |
| |
Learn |
|
|
|
| |
Code | CODE Close | Close | CLOSE Down Force | ||
Button | |||||
|
| Travel Limit | Set Limit | Control | |
|
|
| Button | Adjustment | |
FIG. 7-1 Learn code button and LED
PN# 3642036534, 02/26/2010 REV. 1 | 23 |
