Using the Wall-Mounted Door Control
Press the push button to open or close the door. Press again to
reverse the door during the closing | Push | |
Button | ||
cycle or to stop the door while it’s | ||
| ||
opening. |
|
THE |
|
CONTROL | Push |
Press the push bar to open or close | Button |
| |
the door. Press again to reverse the | Lock |
door during the closing cycle or to | Button |
stop the door while it’s opening. | Light |
Light feature | Button |
Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for
To Open the Door Manually
To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
•If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
•NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
•NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
DISCONNECT TROLLEY:
Lock feature
The door should be fully closed if possible. Pull down on the emergency release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually.
Trolley
Trolley Release
Arm (in Manual
Disconnect
Position)
Designed to prevent operation of the door from
To activate, press and hold the Lock button for 2 seconds. The push bar light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for
The lockout feature prevents the trolley from reconnecting automatically, and the door can be raised
and lowered manually as often as necessary.
TO RE-CONNECT THE TROLLEY:
2 seconds. The push bar light will stop flashing. The Lock feature will also turn off whenever the “Learn” button on the motor unit panel is activated.
Additional features when used with the 3-Button hand-held remote
To control the opener lights:
In addition to operating the door, you may program the remote to operate the lights.
1.With the door closed, press and hold a small remote button that you want to control the light.
2.Press and hold the Light button on the
3.While holding the Light button, press and hold the Lock button on the door control.
4.After the opener lights flash, release all buttons.
Pull the emergency release handle toward the opener
at a 45° degree angle so that the trolley release arm
is horizontal. The trolley will reconnect on the next UP or DOWN operation,
either manually or by using the door control or remote.
Trolley
Trolley Release Arm
NOTICE
To Reconnect
27