INSTALLATION STEP 1

Determine the Header Bracket Location

To prevent possible SERIOUS INJURY or DEATH:

•Header bracket MUST be RIGIDLY fastened to structural support on header wall or ceiling, otherwise garage door might NOT reverse when required. DO NOT install header bracket over drywall.

•Concrete anchors MUST be used if mounting header bracket or 2x4 into masonry.

•NEVER try to loosen, move or adjust garage door, springs, cables, pulleys, brackets, or their hardware, ALL of which are under EXTREME tension.

•ALWAYS call a trained door systems technician if garage door binds, sticks, or is out of balance. An unbalanced garage door might NOT reverse when required.

Installation procedures vary according to garage door types. Follow the instructions which apply to your door.

1.Close the door and mark the inside vertical centerline of the garage door.

2.Extend the line onto the header wall above the door.

You can fasten the header bracket within 4 feet

(1.22 m) of the left or right of the door center only if a torsion spring or center bearing plate is in the way; or you can attach it to the ceiling (see page 9) when clearance is minimal. (It may be mounted on the wall upside down if necessary, to gain approximately 1/2" (1 cm).

If you need to install the header bracket on a 2x4 (on wall or ceiling), use lag screws (not provided) to securely fasten the 2x4 to structural supports as shown here and on page 9.

3.Open your door to the highest point of travel as shown. Draw an intersecting horizontal line on the header wall above the high point:

•3" (7.5 cm) above the high point for sectional door and one-piece door with track.

•8" (20 cm) above the high point for one-piece door without track.

This height will provide travel clearance for the top edge of the door.

NOTE: If the total number of inches exceeds the height available in your garage, use the maximum height possible, or refer to page 9 for ceiling installation.

Unfinished Ceiling

 

OPTIONAL

 

CEILING

 

 

 

 

 

 

MOUNT

 

 

 

FOR

 

 

 

HEADER

Header Wall

2x4

 

BRACKET

 

Vertical Centerline

 

 

 

of Garage Door

2x4

 

 

 

Structural

 

 

 

 

 

 

Supports

Level (optional)

Header Wall

 

 

Header Wall

3" (7.5 cm)

 

 

3" (7.5 cm)

 

 

 

Highest

Track

 

Highest Track

Point of

 

 

Door

Travel

 

Point of

 

 

 

Travel

Door

 

 

 

One-piece door with

Sectional door withhorizontal track curved track

 

Header Wall

 

Header Wall

 

 

 

 

8" (20 cm)

 

8" (20 cm)

 

 

 

Door

 

 

Highest

 

 

Door

Point

 

 

of Travel

 

 

 

Jamb

Highest

 

 

Hardware

 

 

Point

 

 

 

 

Pivot

 

of Travel

 

One-piece door without track: One-piece door without track:

jamb hardware

 

pivot hardware

8