Chamberlain HS670 PROGRAM SETTINGS (DIP SWITCH S1), PROGRAM SETTINGS (DIP SWITCH S2), SLIDE/SWING, “SAVE” SWITCH, MAGLOCK ENABLE, WARNING ENABLE, RIGHT/LEFT OPERATION

P R O G R A M M I N G

PROGRAM SETTINGS (DIP SWITCH S1)

NOTE: For all S1, S2 and S4 switch settings to take effect, the Save Mode switch must be set to the off position.

TIMER TO CLOSE ENABLETIMER TO CLOSE

This switch (S1-1) enables the auto close timer. The timer to close feature works in conjunction with the potentiometer located on the board.

TIMER TO CLOSE

TIMER TO CLOSE

TTC

ENABLED

TTC

DISABLED

SW

RT

SAVE

S1

SW

RT

SAVE

S1

ON

ON

ON

ON

1

2

3

4

1

2

3

4

SL

LT

SL

LT

Max = 180 sec

Min = 0 sec

SLIDE/SWING

This switch (S1-2) selects slide or swing gate operation, in order to optimize gate behavior for specific application.

SL = Slide, 1 second delay

SW = Swing, 1.5 second delay

RIGHT/LEFT OPERATION

This switch (S1-3) selects the gate opening direction, to the left or to the right. Right/Left operation is determined from the inside of fence looking out.

SWING GATE

TTC	SW	RT	SAVE
ON
1	2	3	4
	SL	LT
RIGHT HAND
TTC	SW	RT	SAVE
ON
1	2	3	4
	SL	LT

S1

ON

S1

ON

SLIDE GATE
TTC	SW	RT	SAVE	S1
ON
				ON
1	2	3	4
	SL	LT
LEFT HAND
TTC	SW	RT	SAVE	S1
ON
				ON
1	2	3	4
	SL	LT

“SAVE” SWITCH

This switch (S1-4) stores all settings into memory and locks out changes. NOTE: For any programming changes to take effect this switch must be in OFF position. When switch is ON, no settings can be changed.

	LOCKED				SAVE
TTC		SW		RT
ON			APEMs
1		2		3	4
		SL		LT

S1

ON

UNLOCKED

TTC	SW	RT		SAVE
ON
1	2	3	4
	SL	LT

S1

ON

PROGRAM SETTINGS (DIP SWITCH S2)

NOTE: For all S1, S2 and S4 switch settings to take effect, the Save Mode switch must be set to the off position.

MAGLOCK ENABLE

This switch enables the Maglock feature. On an open command there will be a half second delay after the maglock relay is released before the motor starts.

MAGLOCK ENABLED

S2 MAG WARN OPED CLED

ON

ON

1	2	3	4
		PH	PH

MAGLOCK DISABLED

S2 MAG WARN OPED CLED

ON

ON

1	2	3	4
		PH	PH

WARNING ENABLE

This switch enables the gate “in motion” alarm feature. The alarm will beep 3 seconds prior to movement and throughout movement.

WARNING ENABLED

S2 MAG WARN OPED CLED

ON

ON

1	2	3	4
		PH	PH

WARNING DISABLED

S2 MAG WARN OPED CLED

ON

ON

1	2	3	4
		PH	PH

17