Chamberlain HS670 CONTROL CONNECTION DIAGRAMS, WARNING:, J1 TERMINAL BLOCK, 24VAC ACCESSORY POWER

O P T I O N A L C O N T R O L D E V I C E S

CONTROL CONNECTION DIAGRAMS

11 12 13

19 20

24 25

J1 TERMINAL BLOCK

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Soft Open

Input (N.O.)

R1 R2 R3 R4

24 VAC

24VAC ACCESSORY POWER

Can be found at terminals R1 and R2 located on radio terminal block.

Hard Close

Control Input (N.O.)

OPEN

STOP

Stop/Reset

Control Input (N.C.)

OPEN

STOP

1	2	3
	5	6
7	8	9
7	8
	0	#

Hard Open

Control Input (N.O.)

OPEN

STOP

Interrupt (Safety) Loop Input (N.O.)

NOTE: See wiring diagrams shipped with kit for additional information. See owner’s manual for wiring distances and wire gauge information.

WARNING: All controls that are to be used to operate the gate system, must be installed where the user cannot come into contact with the gate while operating the controls where the user has full view of gate operation.

All inputs are normally open and momentary, except the stop (N.C.). The following instructions are based upon UL325, and include recommendations for significant increase in safety.

*We strongly recommend that you follow the UL guidelines presented throughout the manual. Refer to instructions shipped with optional control devices for mounting, wiring, programming and adjustment. Installation device instructions: Always follow the instructions provided by the manufacturer when installing and adjusting any control device. If these instructions are contrary to the advice given here, call for assistance.

Shadow Loop		Q
		REF
Input (N.O.)
		Obstruction Open
Q RE	F	Edge/Photo Eye Input (N.O.)
Residential Radio
(Single Button) Input (N.O.)
		Obstruction Close
		Edge/Photo Eye Input (N.O.)