Channel Plus MDS-6A Wiring Mcs Controllers - Cont, MCS Controller DIP Switch Configuration

MDS-6AINSTALLATION MANUAL

2.2- WIRING MCS CONTROLLERS - CONT.

MCS Controller DIP Switch Configuration

When connecting MCS Controllers to the MDS-6A, all dip switches on all MCS

Controllers should be configured to reflect their correct Zone ID.

Figure 7		DIP SWITCH #		4
MDS-6A ZONE	1	2	3

1		X	ON	ON	ON
		#1 OFF=Back
2			OFF	ON	ON
		X
		Light ON
	3	X	ON	OFF	ON
4		X	OFF	OFF	ON
		#1 ON=Back
5		Light OFF	ON	ON	OFF
		X
6		X	OFF	ON	OFF

NOTE: If more than one MCS Controller is to be installed in a single zone, all wiring should be paralleled (as illustrated in Figure 6C on the previous page) and both MCS Controllers should be assigned the same Zone ID.

Page 10 © Channel Plus, Inc. 2004 • All rights reserved. 4/04