Performance characteristics
Inline skating with the Stroller is not permitted.
Assembly
To attach the stroller wheel, press the plastic button on the side of the VersaWing 2.0 until it can go no further. Then, from below, insert the upward pointing caster shaft of the stroller wheel into the vertical hole of the VersaWing 2.0 until it can go no further.
If you want to convert the carrier from Stroller to another CTS Conversion Kit, you can store the stroller wheels on the top of the VersaWing 2.0 .
To attach them proceed as described above.
The caster fork arms should point forwards.
Release the plastic button. This now clicks back towards the outside, resulting in locking of the attachment axle of the stroller wheel.
DANGER
Always make sure that the stroller wheels are properly and fully engaged and locked. To check this pull the stroller wheels up and down in a vertical direction. Make sure that the plastic locking button has fully clicked back. Incorrect assembly may lead to accidents.
DANGER
Always make sure that the stroller wheels are fully engaged and locked.
Travelling
Weight distribution
DANGER
So as to prevent it from tipping backwards, the storage compartment at the rear of the carrier may not be loaded with excessive weight. Carry out the following check: push downwards on the handlebar by about 150 mm. The carrier should return to its original standing position and should not tip backwards.
30
