Chauvet Indoor Furnishings Master/Slave Fixture Linking, Mounting, O R I E N T At Io N, Rigging

DMX4.5	DMX Cable 4.5m/14.8ft
DMX10	DMX Cable 10m/32.8ft

Master/Slave Fixture Linking

1.Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture.

2.Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.

Often, the setup for Master-Slave and Standalone operation requires that the first fixture in the chain be initialized for this purpose via settings in the control panel. Secondarily, the fixtures that follow may also require a slave setting. Please consult the “Operating Instructions” section in this manual

type of and configuration.

Slave

Slave

Master

Mounting

O R I E N T AT IO N

This fixture may be mounted in any safe position.

RIGGING

Mount the fixture using, a suitable “C” or “O” type clamp.

Adjust the angle of the fixture by loosening both knobs

tilting the fixture. After finding the desired position, retighten both knobs.

When selecting installation location, take into consideration fuse replacement and routine maintenance.

2 clamps must be used with this fixture. Safety cables must always be used.

Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.

Hanging Clamp

and

Note!

Clamp is sold separately.

COLORstrip™ Mini User Manual 10 1/26/2010 2:49 PM