Chauvet Indoor Furnishings Master/Slave & Stand Alone, Built in programs detailed, SYS S Aad

SYS

S Aad

Re-initialize fixture

Re-establishes correct number of down-link fixtures for sequential chase runs.

Master/Slave & Stand Alone

The Master/Slave mode will allow you to link units in a daisy chain fashion. In this mode, the first unit in the daisy chain will command all other units following. Stand Alone can simply be achieved by setting all units to Master. They would no longer be required to be linked in series.

MASTER UNIT Settings

Press the Mode button. Then, by using the

Up/Down buttons, select [] and press the Enter button.

Select programs by using the Up/Down buttons. Press the Enter button.

Some programs have additional controls such as flash and run speed. Press the Mode button to toggle

additional functions, then use the Up/Down

buttons to change values.

Refer to the Control Panel Modes & Functions

chart on the previous page.

SLAVE UNIT Settings Units that follow the Master unit will automatically synchronize to

the Master unit. No other

settings are required.

Master/Slave Link

Master

3 Pin XLR DMX cable

Slave

Slave

Slave

DMX signal output does not continue on M/S linked fixtures.

IMPORTANT INSTRUCTIONS FOR MASTER/SLAVE OPERATION

Turn ON the Master unit last! This will assure that the Master unit will fully detect all linked units, and re-configure its

built-in sequential chase programs to run on the correct number of linked units.

Built in programs detailed

	PROGRAM	FUNCTION		OPTIONS
	000	Blackout
	001-007	Solid flashing colors		F = Flash speed
008-013		Color chase programs		P = Run speed
				F = Flash speed
014-020		Sequential color chase patterns		Use sound sensitivity rotary knob to adjust sound
				level for optimum response or decrease sensitivity
				completely to operate in Run speed only
				P = Run speed
021		RGB (manual color mix)		P = Red
COLORstrip™ Mini User Manual			12	1/26/2010 2:49 PM