3.SETUP
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
Fuse Replacement
1.With a flat head screwdriver, wedge the fuse holder out of its housing.
2.Remove the damaged fuse from its holder and replace with exact same type fuse.
The fuse is located inside this compartment. Remove using a flat head screwdriver.
3.Insert the fuse holder back in its place, and reconnect power.
Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a
Important: Fixtures on a serial data link must be daisy chained in one single line. To comply with the
Maximum recommended serial data link distance: 500 meters (1640 ft.)
Maximum recommended number of fixtures on a serial data link: 32 fixtures
Data Cabling
To link fixtures together you must obtain data cables. You can purchase
DMX D AT A C ABLE
Use a Belden© 9841 or equivalent cable which meets the specifications for EIA
2-conductor twisted pair plus a shield
Maximum capacitance between conductors – 30 pF/ft. Maximum capacitance between conductor and shield – 55 pF/ft. Maximum resistance of 20 ohms / 1000 ft.
Nominal impedance 100 – 140 ohms
COLORstrip™ Mini User Manual | 8 | 1/26/2010 2:49 PM |