Chicago Electric 42933 operating instructions Specifications, Unpacking, Installation

Specifications

Power	120 V~, 60 Hz, 1-ph
Requirements	20.9 A (start); 6.9 A (load); 1330 W
Motor	1-3/4 HP, 4200 spindle RPM,
	electric brake
Saw Blade	8-1/4” (dia.)
Arbor	5/8”
Crosscut Distance	11” (maximum)
Rip Cut Distance	20” (maximum)
Depth of Cuts	45°: 2”; 90°: 2-1/8”
Bevel Index Stops	0, 45, 90°
Mitre Index Stops	Left and right: 0, 15, 30, 45, and 60°
Table Size	15-1/16 x 27-5/8 x 3/4”
Accessories	Blade Replacement: Item # 43204

Note: Performance of this tool may vary depending on variations in local line voltage. Extension cord usage may also affect tool performance.

•The workbench should be of the ap- propriate length and width to allow the operator to stand aside of the saw blade, whatever position the saw blade is in.

•The work area should have ade- quate, overhead, non-glare lighting.

•Lock the radial arm carriage before moving the unit.

Unpacking

When unpacking, check to make sure that all the parts are included. Refer to the Parts List and Assembly Drawing at the end of this manual. If any parts are miss- ing or broken, please call Harbor Freight Tools at 1-800-444-3353 as soon as pos- sible.

Installation

During the assembly and installation procedure, you may have to refer to the Parts List and Assembly Drawings located at the end of this manual.

1.Secure the Radial Arm Saw to a solid bench top (or table) by bolting (or clamping) the saw frame down to the bench top.

•The workbench must not be able to slide or tip over. Affix to floor if nec- essary.

•Position the Radial Arm Saw (or saw and bench) to slope slightly to the rear so the radial arm carriage will not roll forward due to gravity.

2.Turn the Base (152) assembly upside down. Attach Table A (127) squarely to the Base assembly using the four cross-head Tapping Screws (165).

3.Attach the table stabilizer Stands to both sides of the Base using four Hex Nuts (82), Washers (149), and Round Head Bolts (148).

4.Place the Table and Base assem- bly on the workbench, right side up. Secure to the workbench with nuts, bolts, and washers (not supplied).

5.Position Table B (126) and Table C (125), and the rip fence (guide) and

REV 01c

SKU 42933 For technical questions, please call 1-800-444-3353. Page 10