To Install A Router Bit:
1.WARNING! Make sure the Power Switch of the Router Table is in its “OFF” position and the Router Table is not plugged into an electrical outlet.
2.Fully insert the Router Bit (not included) into the Collet Chuck (5A). Firmly tighten the Collet Chuck with the two accessory Wrenches (10B, 11B). (See Figure E.)
To Adjust The Depth Of The Cut:
COLLET CHUCK
WRENCH(5A) (10B)
WRENCH 11B)
Figure E
ROUTER TABLE POWER SWITCH
&
OUTLETS
DEPTH
ROD (18A)
Figure F
KNOB (12A)
1.Loosen the Lock Lever (8A). Then, loosen the Knob (12A).
(See Figure F and Assy. Diagram A.)
2.Adjust the Router to obtain the required cutting depth. Then, retighten the Lock Lever.
3.Adjust the Depth Rod (18A) on the Router to read “0” when the router bit is flush with the table top. Check to make sure that even if released with the
Lock Lever, the Router stops at the determined depth for repeated cuts.
Note: Minute depth adjustments (in 1/16” increments) can be made by raising or lowering the Depth Rod (18A). (See Figure F and Assy. Diagram A.)
SKU 95380 | For technical questions, please call | PAGE 12 |
