Manuals / Kenwood / Kitchen Appliance / Range

Kenwood CK 740 manual Gas Section, Gas Installation, Gas Connection, Important Note

Models: CK 740

1 48

Download 48 pages 10.47 Kb

Page 39

9 - GAS SECTION

GAS INSTALLATION

IMPORTANT NOTE

This appliance is supplied for use on NATURAL GAS only and cannot be used on any other gas without modification.

This appliance is manufactured for conversion to LPG if required and is supplied with a conversion kit.

The cooker must be installed by a qualified person in accordance with the Gas Safety (Installation and Use) (Amendment) Regulation 1990 and the relevant building/l.E.E. Regulations.

The following British Standards should be used as reference when installing this appliance.

BS6172 1990, BS5440 part 2 1989 and BS6891 1988.

Failure to install the appliance correctly could invalidate any manufacturers warranty and lead to prosecution under the above quoted regulation.

In the UK C.O.R.G.I registered installers are authorised to undertake the installation and service work in compliance with the above regulations.

GAS CONNECTION

The installation of the cooker to Natural Gas or LP Gas must be carried out by a qualified gas engineer. Installers shall take due account of the provisions of the relevant British Standards Code of Practice, the Gas Safety Regulations and the Building Standards (Scotland) (Consolidation) Regulations issued by the Scottish Development Department.

INSTALLATION TO NATURAL GAS

Installation to Natural Gas must conform to the Code of Practice, etc. The supply pressure for Natural Gas is 20 mbar.

INSTALLATION TO LP GAS

This appliance must only be connected to LPG after an LPG conversion kit has been fitted, (see pages from 39 to 40). When operating on Butane gas a supply pressure of 28-30 mbar is required.

When using Propane gas a supply pressure of 37 mbar is required.

The installation must conform to the relevant British Standards.

Warning: Only a qualified gas engineer, also with technical knowledge of electricity should install the cooker. He should observe the Regulations and Codes of Practice governing such installation of gas cookers.

Note: It is recommended that the gas connection to the cooker is installed with a flexible connecting tube made to BS 5386.

39

Image 39

Kenwood CK 740 manual Gas Section, Gas Installation, Gas Connection, Important Note, Installation To Natural Gas

Contents

DUAL FUEL DOUBLE OVEN COOKER Instructions for use - Installation advicePage CONTENTS FIRST USE OF THE OVEN IMPORTANT SAFEGUARDS AND RECOMMENDATIONS COOKING HOB 1 - COOKING HOB2 - CONTROL PANEL CONTROL PANEL - Controls descriptionPilot lamps 3 - USE OF COOKING HOB GAS BURNERSLIGHTING THE BURNERS BURNERS DEEP FAT FRYINGCHOICE OF THE BURNER CORRECT USE OF RAPID BURNERWRONG CORRECT USE OF TRIPLE-RINGFig. 3.5a Fig. 3.5bAttention the oven door becomes very hot during operation GENERAL FEATURES4 - MULTI-FUNCTION MAIN OVEN OPERATING PRINCIPLESFUNCTION SELECTOR KNOB fig TEMPERATURE KNOB figOVEN LIGHT TRADITIONAL CONVECTION COOKINGRecommended for GRILLINGDEFROSTING FROZEN FOODS HOT AIR COOKINGCONVECTION COOKING WITH VENTILATION VENTILATED GRILL COOKINGUse with the oven door closed THAWING AND WARMING UPUSE OF THE GRILL OVEN COOKINGROASTING GRILLING AND “AU GRATIN”BREAD & PASTRY COOKING CHARTCOOKING GUIDE CAKESKeep children away 5 - CONVENTIONAL OVENGENERAL FEATURES Attention the oven door becomes very hot during operationTRADITIONAL CONVECTION COOKING TEMPERATURE KNOB FigFUNCTION SELECTOR KNOB fig OVEN LIGHTRecommended for PLATE WARMINGSPIT ROASTING GRILLINGBREAD & PASTRY COOKING CHARTCOOKING GUIDE CAKESUSE OF THE GRILL ROTISSERIE FigUSE OF THE ROTISSERIE OVEN COOKINGUSING THE SPECIAL RACK FOR NORMAL COOKING USE OF SPECIAL DISH RACKUSING THE SPECIAL SHELF AS A DISH RACK Description of the illuminated symbols Description of the buttons6 - ELECTRONIC PROGRAMMER If the oven is switched on, you must switch off manually ELECTRONIC TIMERSETTING THE FREQUENCY OF THE AUDIBLE SIGNAL ELECTRONIC CLOCK figThe cooking program may be can- celled at any time by pushing AUTOMATIC OVEN COOKINGSEMI - AUTOMATIC COOKING The cooking program can be can- celled at any moment by pushing thebutton STAINLESS STEEL SURFACES 7 - CLEANING AND MAINTENANCEGENERAL ADVICE ENAMELLED PARTSBURNERS CORRECT REPLACEMENT OF THE BURNERSTRIPLE RING BURNER OVEN DOOR STORAGE COMPARTMENTThe storage compartment is accessible through the pivoting panel fig INSIDE OF OVEN FITTING THE OVEN OUTADVICE FOR USE AND MAINTE- NANCE OF SELF CLEANING PANELS Fig. 7.10D REMOVING THE OVEN DOORFig. 7.10A Fig. 7.10B Fig. 7.10CThis film must be removed before using the cooker Advice for the installerINSTALLATION 8 - INSTALLATION+ 8 mm + 35 mm LEVELLING THE COOKERIt is important to observe the prescrip- tions of figures 8.3 0 + 8 mmBACKGUARD MOVING THE COOKER When moving the cooker to its final posi- tion DO NOT DRAG figLift feet clear of floor fig MINIMUM PERMANENT OPENING FREE AREA FOR FLUELESS APPLIANCE PROVISION FOR VENTILATIONINSTALLATION TO NATURAL GAS GAS INSTALLATION9 - GAS SECTION GAS CONNECTIONPlug GAS CONNECTIONCONVERSION TO LPG 1 - Injectors replacement of top burners2 - Adjusting of the minimum of the top burners LUBRICATION OF THE GAS TAPSTABLE FOR THE CHOICE OF THE INJECTORS Cat II 2H3+ The connection of the appliance to earth is mandatory 10 - ELECTRICAL SECTIONGENERAL This appliance must be earthedELECTRICAL FEEDER CABLE CONNECTION FEEDER CABLE SECTION TYPE HO5RR-FL1 N PE GUARANTEE AFTER SALES SERVICEUK only Page Descriptions and illustrations in this booklet are given as simply indicative Part Number 54070/1 code 1101991 ß4