Carbon Brush | Carbon Brush | |
(52) | ||
Holder Spring | ||
|
Carbon
Brush
Holder (53)
Housing
SlotGearbox
Tab
Wire Fixing
Board (50)
Figure 10
7.Remove the Wire Board from the top of the Carbon Brush Holder (53). Then use tip of
8.CAUTION! The spring must be clear of the Holder lip to remove Carbon Brush.
9.Use the screwdriver to slide the Carbon Brush from the Holder. Then replace with new Carbon Brush.
10.Snap spring back into place and use Screw to replace Wire Board.
11.To better access the second Carbon Brush, turn the Breaker Hammer over. Repeat Steps 7 to 10 to replace second Carbon Brush.
Figure 11
12.Once both Carbon Brushes have been replaced, slide Gearbox shut. CAUTION: When closing Gearbox, make sure tab along rim of Gearbox aligns with the slot in the housing. See Figure 11.
13.Use the four screws to fasten the Gearbox back into place. Then replace
Left Handle and fasten that into place against Gearbox. Replace Cover and fasten it into place using the Screws.
SKU 96035 | For technical questions, please call | Page 15 |
