General Operating Instructions
Power Switch
Reset Button
Fig. 3
1.When making a flat cut, slide the piece to be cut up against the two Fence (D09,D12) halves securely and stabilize one side with the provided Clamp Plate.
2.When making an angled cut, position one end securely at the point where the two Fence halves come together. Use the Clamp Plate to secure it. The
3.To make a cut, the material to be cut must be placed against the fence and secured by the the Clamp Plate. The sliding unit must be located at the far end of the unit, opposite the Fence and mate- rial to be cut.
4.With the saw and the water pump turned on and operating, pull Handle to move blade through material at a slow and steady pace.
5.Do not attempt to cut on a push stroke, the blade may grab the workpiece.
Knob
Sliding Bar
Support
Bevel Scale
Fig. 4
6.Beveled cuts can also be accomplished by loosening the Knobs (D27) on either side of the saw. Tilt the Sliding Supports, and blade/motor assembly as a unit. There is a scale and indexing pointer on the Sliding Supports indicating angle of tilt. (See Fig. 4.)
7.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool indoors out of children’s reach.
SKU 98265 | For technical questions, please call | Page 13 |
