SECTION 5
SERVICE TECH INFORMATION
|
| 5A. |
| TROUBLESHOOTING | |||
should | get a | reading | in the | display. | If you | get a | 3. Press the #1 SELECT button and hold 3 seconds |
reading, | unhook | the | in and out | plumbing | and | check | until... |
the turbine for binding. | ...SFaashows. | H; 2 |
| ||
MOTOR |
| |
|
|
POSITION SWITCH
SENSOR HOUSING
TURBINE
This code identifies the softener nominal capacity size. If the wrong number shows, the softener will operate
on incorrect programming. Do the following as needed.
TURBINE
SHAFT
VALVE
VALVE POSITION INDICATORS: Depending on the
valve position, the following indicators show in the display:
INDICATOR | VALVE | POSITION |
Serv | service | |
Fill | fill |
|
Brine | brining/brine rinse | |
Bkwash | backwash | |
Rinse | fast | rinse |
When the valve is rotating from 1 cycle to another, both indicators flash. For example, if the valve is in transition between fill and brining, both Fill and Brine flash. Upon reaching brining position, Fill goes off and Brine is on steady. The time display shows the minutes of the cycle remaining.
NOTE: If the face plate is left in a diagnostic display
(or a flashing display when setting times or] hardness), present time automatically returns if a button is not pressed within 4 minutes. To return to
the diagnositc display, repeat step 2.
OTHER INFORMATION. While in this diagnostic screen, the following information is available and may be beneficial for various masons. This information is retained by the computer from the first time electrical power is applied to the face plate.
...Press [] to display the number of days this face plate has3_ad electrical Power applied.
...Press [_ to display the number of regenerations initiated by this face plate since the HF code number was entered.
HF32 does show
To | change |
| HF | number | - | Press | the | [] | or | |||
[] | button | until | HF32 | shows. | Then, | press | the | #1 | ||||
SELECT button and reset the timer...page 6. |
|
| ||||||||||
FACE PLATE REPLACEMENT: Be sure the valve |
| |||||||||||
is | in | service | position |
| (observe | valve cycle |
| |||||
indicator) |
| when | replacing | the face | plate. |
| ||||||
If, after installing | and | programming | the | replace- |
| |||||||
ment | face | place, | the valve | _ | in | service | posi- |
| ||||
tion, do the following to assure correct cycle |
| |||||||||||
orientation, |
| or | timing, | between the face plate |
| |||||||
and | valve. |
|
|
|
|
|
|
|
|
|
| |
Use | the MANUAL ADVANCE | procedures, | page |
| ||||||||
24.With the RECHARGE NOW button, advance through the recharge cycles until the valve stops
in service position, and RECHARGE no longer flashes in the timer.
NOTE: The valve motor may automatically drive through several valve positions while searching for service. If an error code occurs, unplug the transformer, then plug in again.
11"10NI
markers
(valve in service)
CAM
23
