Kenmore 625.34867 owner manual Section, Watersoftenerstart-Up

SECTION 1		WATERSOFTENERSTART-UP
!		!
lB.	CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL

To be sure you have done all the steps to install the

softener, read the following list. Refer to the-".t::Installation Manual, part no. 7183613, for step-by-step

guides.

Page numbers referred to are in the Insta/Iation

Manua/unless otherwise noted.

€' Is the house water flow going INTO the softener valve INLET?.Trace piping to be sure. See pages 10 and 11.

_ VALVE

INLET

I/ Is the plumbing bypass valve (or 3 valves) set for SERVICE? See FIG. 12, page 20 of this manual.

v' Is the valve drain hose connected the right way, and without sharp bends or kinks that could stop or reduce water flow? See page 16.

Page numbers referred to are in the Insta//ation

Manua/unless otherwise noted.

v' Is the softener power cable connected to the trans-

former? Is the transformer plugged into an inside,

120V-60Hz electrical outlet? See page 20 in the

installation manual, and the wiring schematic on page 21 of this manual.

plastic

Jt/;

3-valve _- _ !

v' Be sure to restart the water heater. See page 20.

5