Kenmore 625.34867 owner manual Program The Timer, Water Softener Start-Up, Section, R20 -iT

SECTION 1

WATER SOFTENER START-UP

3

1C.			PROGRAM THE TIMER
salt level	low salt		ON/OFF-HOLD button	#1 SELECT
			(Recharge Tonight-Now)	button	UP button
adjust button	indicator
	\	\		/
f

GeniusII WaterSo#ener

KenmoreWaterLine

forCustornerAssistance #.u_J

'_ 1-800-426-_,/./ _

J

	/		/	display	#2 SELECT	DOWN button
signal	light	tank	light
adjust	button	on/off	button		button

When the transformer is plugged in, the model code

HF32, and a test number (example: A2.0) show in the

faceplate display for 4 seconds. Then, 12:00 AM and PRESENT TIME begin to flash.

.....	I -i f-lr-i,_
....	C,ULI

R20 -iT

NOTE:

If HF-- shows in the display, press the UP [_ or

DOWN [_ button until HF32 shows. Then, press the #1 SELECT button to set, and change to the flashing PRESENT TIME display.

To check the model code, unplug the transformer at the wall outlet and plug in again. If other than HF32 shows, see page 19 to reset.

SOUND "BEEPER": A "beeper" sounds while pressing buttons for timer set-up. One beep signals a change in the faceplate display. Repeated beeps mean the timer will not accept a change from the button you have

pressed_ telling you to use another button. For

example, while setting the hardness (step 2), the

beeper sounds repeatedly when the display reaches 1

using the DOWN button, or the highest hardness setting using the UP button.

1.SET PRESENT TIME OF DAY:

NOTE:

If the words...PRESENT TIME do not show in the display, press the #1 SELECT button (FIG. 1) until they do, or see the notes above.

• Press the _ UP/DOWN{_ buttons to set the

present time. Press UP to move the display ahead; press DOWN to move the time backward.

If the	present		time	is	between			%0-
noon	and	midnight,		be	sure	PM	'i
shows.								_ltE
If the	present		time	is	between
midnight		and	noon,	be	sure	AM
showsNOTE:.							I"....'",
Each	press		of the	UP/DOWN			J

buttons changes the time by 1] { [ minute. Holding the buttons in"""

changes the time 32 minutes each second.

2.SET WATER HARDNESS NUMBER:

• Bress the #1 SELECT button once to display 25

(flashing) and HARDNESS.

='-" 25

The grains per gallon (gpg) ",'"

							7
hardness		of	your	water	supply	is	_
on your		water analysis			report.	Be
sure	to	enter	water	test	results	on	*,
page	2,	for	future	reference.		"	"

6