RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS
(120 VOLT)
NAMEPLATE | EXTENSION CORD | |||
AMPERES |
| LENGTH |
| |
(at full load) | 25’ | 50’ | 100’ | 150’ |
0 – 6 | 18 | 16 | 16 | 14 |
6.1 – 10 | 18 | 16 | 14 | 12 |
10.1 – 12 | 16 | 16 | 14 | 12 |
12.1 – 16 | 14 | 12 | Do not use. | |
TABLE A
9.USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an exten- sion cord, be sure to use one heavy enough to carry the current your prod- uct will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table A shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
10.WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry which may get caught in moving parts. Nonslip footwear is recommended. Wear protective hair covering to contain long hair.
11.ALWAYS USE SAFETY GLASSES. Also use face or dust mask if cutting operation is dusty. Everyday eyeglasses only have impact resistant lenses, they are NOT safety glasses.
12.SECURE WORK. Use clamps or a vise to hold work when practical. It’s safer than using your hand and it frees both hands to operate tool.
13.DON’T OVERREACH. Keep proper foot- ing and balance at all times.
14.MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and saf- est performance. Follow instructions for lubricating and changing accessories.
15.DISCONNECT TOOLS before servicing; when changing accessories, such as blades, bits, cutters, and the like.
16.REDUCE THE RISK OF UNINTENTION- AL STARTING. Make sure switch is in off position before plugging in.
17.USE RECOMMENDED ACCESSORIES. Consult the owner’s manual for recom- mended accessories. The use of improp- er accessories may cause risk of injury to persons.
18.NEVER STAND ON TOOL. Serious inju- ry could occur if the tool is tipped or if the cutting tool is unintentionally contacted.
19.CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended func- tion – check for alignment of moving parts, binding of moving parts, break- age of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced.
20.DIRECTION OF FEED. Feed work into a blade or cutter against the direction of rotation of the blade or cutter only.
21.NEVER LEAVE TOOL RUNNING UNAT- TENDED. TURN POWER OFF. Don’t leave tool until it comes to a complete stop.
SKU 98265 | For technical questions, please call | Page 3 |
