Installing the Battery Pack
1.Place the battery pack in the tool, aligning the arrows on the battery pack with the arrows on the tool.
2.Press the battery pack into the tool. Make sure that the battery pack snaps into place, and that the battery pack is secure in the tool before beginning use.
Removing the Battery Pack
1.Press the Release Tabs (19) on both sides of the battery pack to release the battery from the tool.
2.Remove the battery pack from the tool by pulling straight out.
Inserting or removing a bit from the tool.
Note: Only use accessories that are rated at or above the RPM rating of the Cordless Rotary Tool.
WARNING: Always allow the motor to come to a complete stop before engaging the spindle lock.
WARNING: Always remove the battery pack before making any adjustments or changing bits, to prevent accidental starting of the tool. Accidental starting of the tool may result in serious personal or property injury.
1.Depress the Spindle Lock (10). Rotate collet until shaft is engaged by the lock.
2.Loosen the Collet Nut (1) by turning it counterclockwise, using the Wrench provided.
Wrench
Collet Nut (1)
Spindle Lock (10)
WARNING: If you are changing a bit immediately after use, be careful not to touch the bit. It may be very hot from use, possibly causing injury. Allow the bit time to cool before handling it.
3.To remove a bit: Pull the bit straight out of the Collet once the Collet Nut is
loose. To insert a bit: Insert the shank end if the bit into the Collet once the Collet Nut is loose.
SKU 92880 For technical questions please call | Page |
