Operation
1.Charge the Battery Pack (18) and insert it in the tool, as described in the previous section.
2. Select an appropriate bit or attachment | Switch |
for the job. Insert the bit or attachment as |
|
described in the previous section. |
|
3.The LED Lighted Collar may be turned on by moving the switch on the collar.
4.Rotate the Switch (8) to the ON position. NOTE: This is a variable speed switch. The tool bit speed is dependent on the position of the Switch. Use a speed appropriate to the bit and the material being worked on. In general harder materials require faster
speeds and softer materials require slower speeds. Relative speeds are indicated by the numbers on the Switch.
5.Apply the tool bit to the work material as needed.
6.When the task has been completed, stop the tool by rotating the Switch (8) to the OFF
(“O”) position. If the LED Collar light is ON, switch it OFF. Unplug the rechargeable battery. Remove the bit or attachment as discussed in the previous section.
7.Store the tool, its battery, and its bits and attachments in their case in a safe location.
8.Dispose of used batteries properly. Consult your local hazardous waste authority for disposal guidelines.
Maintenance
1.A plastic storage case has been provided for safe storage of your Rotary Tool and its bits, parts and accessories. Always store your tool and its accessories in the case provided.
2.Protect the tool and its parts and accessories from moisture and damp or corrosive atmospheres.
3.Keep this tool out of reach of children and other unauthorized persons.
4.Protect this tool from damage. Do not leave it in a place where it can be banged around, such as a truck bed or vehicle trunk.
5.Some of the bits provided are “grinding bits” using stone abrasives. During use, these may clog up with removed material or lose their shape. To clean and reshape these bits, run them against the provided Dressing Stone. The Dressing Stone will abrade away the clogging materials and will reshape the Grinding Bits as appropriate.
SKU 92880 For technical questions please call | Page |