Chicago Pneumatic CS7000 manual Gen2 Tool Control Module TCM, Front View of the TCM

6159939130 CS7000 Controller Hardware Overview Manual

Gen2 Tool Control Module (TCM)

The TCM, shown in Figure 2-6, is a device that controls a single DC electric tool. The TCM and its attached tool are referred to as a spindle. The TCM houses both the servo amplifier and DCM.

Figure 2-6. Front View of the TCM

WARNING!

!

This servo contains a fast discharge circuit to discharge the internal capacitors within a few seconds. However, you should still be careful when handling the TCM. A “bus voltage present” light on the front of the unit will extinguish when the bus voltage has dropped below approximately 70VDC.

Page 2-8 39-30-41365