Chief Manufacturing FSD-4100 Adjustments, Screen Height Adjustment, Arm Tension Adjustment

Models: FSD-4100

1 11

Page 7

Installation Instructions	FSD-4100

1.Using a screw driver, slightly loosen the screws (40

or 50) securing the display panel to the mounting bracket (see Figure 4).

2.Adjust the display panel to the desired height.

3.Using a screw driver, tighten the screws securing the dis- play panel to the mounting bracket.

CAUTION: Overtightening adjustment bolt will cause exces- sive wear and may distort adjustment components.

1.Using a 5/32” Allen wrench (80), slightly tighten or loosen the tension adjustment bolt at the base of the arm (see Figure 5).

2.With display mounted, cycle the FSD to check for desired tension.

3.Repeat Step 1 and Step 2 until desired tension is obtained.

Securing

Monitor

Image 7

Contents

I N S T A L L A T I O N I N S T R U C T I O N S BEFORE YOU BEGINCHIEF MANUFACTURING INC FSD-4100 LCD Flat Screen Swing-DownMountTOOLS REQUIRED FOR INSTALLATION IMPORTANT WARNINGS AND PRECAUTIONSCONTENTS Installation Instructions DIMENSIONAL DRAWINGFSD-4100 INSPECT THE UNIT BEFORE INSTALLING PARTS Locations Figure 2. Mark Mounting Location Secure FSD-4100INSTALLATIONMOUNT THE DISPLAY Base CoverScrews Figure 1. Remove Cover Mark HoleTension Adjustment Bolt ADJUSTMENTSScreen Height Adjustment Arm Tension AdjustmentFigure 8. Route & Tie Wrap Cables Arm CABLE MANAGEMENTFigure 6. Cable Management Cover Figure 7. Route Cables Down Arm Tie WrapsFigure 9. Route & Tie Wrap Cables Base Figure 10. Install Base and Cable CoversRight and Left 35 Degree Rotation 35 Degrees Stop Tie Wrap SlotFigure 13. Wrap Cables In Base Right and Left 110 Degree Rotation35 Degree Stop Figure 11. Remove 35 Degree Stop 110 Degrees Figure 12. Rotate 110 DegreesFigure 14. Rotate In One Direction Check RotationFigure 15. Rotate In Opposite Direction