Chief Manufacturing FSD-4100 Right and Left 110 Degree Rotation, Degrees . Rotate 110 Degrees

Models: FSD-4100

1 11

Page 10

1.Using an Allen wrench (provided), remove the 35 degree stop (see Figure 11).

2.Turn the base 110 degrees in one direction to its stop (see Figure 12).

3.Neatly and carefully, wrap power/audio/video cables twice inside base with no slop or slack in cables (see Figure 13).

4.Route power/audio/video cables out access hole in base.

5.Secure cables to base using a tie wrap (70).

6.Trim excess from tie wrap.

7.Install cable cover (10B) on arm and secure using screw (see Figure 10).

8.Install base cover (10A) on base and secure using two screws (see Figure 10).

Figure 11. Remove 35 Degree Stop

Figure 12. Rotate 110 Degrees

Image 10

Contents

FSD-4100 LCD Flat Screen Swing-DownMount BEFORE YOU BEGINCHIEF MANUFACTURING INC I N S T A L L A T I O N I N S T R U C T I O N STOOLS REQUIRED FOR INSTALLATION IMPORTANT WARNINGS AND PRECAUTIONSCONTENTS Installation Instructions DIMENSIONAL DRAWINGFSD-4100 INSPECT THE UNIT BEFORE INSTALLING PARTS Base CoverScrews Figure 1. Remove Cover Mark Hole FSD-4100INSTALLATIONMOUNT THE DISPLAY Locations Figure 2. Mark Mounting Location SecureArm Tension Adjustment ADJUSTMENTSScreen Height Adjustment Tension Adjustment BoltFigure 7. Route Cables Down Arm Tie Wraps CABLE MANAGEMENTFigure 6. Cable Management Cover Figure 8. Route & Tie Wrap Cables Arm35 Degrees Stop Tie Wrap Slot Figure 10. Install Base and Cable CoversRight and Left 35 Degree Rotation Figure 9. Route & Tie Wrap Cables Base110 Degrees Figure 12. Rotate 110 Degrees Right and Left 110 Degree Rotation35 Degree Stop Figure 11. Remove 35 Degree Stop Figure 13. Wrap Cables In BaseFigure 14. Rotate In One Direction Check RotationFigure 15. Rotate In Opposite Direction