PDC Series | Installation Instructions |
May remove pin and nut and move to lower holes
1
2
A padlock or bolt may be placed through latch holes
2 | Remove bolt |
|
| or padlock | 3 |
| if used | |
Pin in |
| |
"Closed" |
| |
position - |
| |
move to |
| |
"Open" |
| |
position to |
| |
remove |
| |
display |
| |
| 5 |
|
Figure 4
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Ensure mounting buttons are completely engaged in mounting holes.
NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 4)
3.Connect and secure power, audio and video cables.
Removing Displays from PDC
1.Disconnect all power/audio/video cables.
2.Remove bolt or padlock from faceplate (if used). (See Figure 5)
NOTE: The pin may have been used as a more permanent locking device. If so, remove nut and pin and move from the lower holes to the upper holes.
3.Pull back on flag on upper mounting hole and press pin down down into "Open" position. (See Figure 5)
Pin in |
"Open" |
position - |
move to |
"Closed" |
position |
after display |
is removed. |
Figure 5
WARNING: EACH DISPLAY MAY WEIGH IN EXCESS OF 40 LBS EACH! Always use two people and proper lifting techniques when installing or positioning displays on PDC.
4.Carefully lift displays from PDC.
5.Lift up on pin and place flag back against faceplate to return it to "Closed" position. (See Figure 5)
Adjustments
Roll Adjustment
1.Loosen two Nylock nuts inside the PDC. (See Figure 6)
2.Using the slotted holes, adjust the roll, or horizontal movement.
3.Tighten two Nylock nuts.
6