Installation Instructions | PLP Series |
ATTACH PSB TO THE DISPLAY
To attach the PSB to the display, do the following:
To help your identify the correct PSB that matches the model number of your display, refer to the cross- reference chart at www.chiefmfg.com.
To download the corresponding PSB installation instructions, refer to www.chiefmfg.com.
OR
Contact Customer Service at
INSTALL THE DISPLAY
To install the display, do the following:
NOTE: Verify that all power/audio/video cables are disconnected from the display and the latching flag is lowered in the down position before attempting to mount the display.
1.With the aid of another person, lift the display up to the mount on the wall, aligning mounting buttons with the teardrop slots on the mount, and lower the display firmly into place (Figure 8).
2.Raise the latching flag to secure the display (see Figure 9). If the flag does not fully engage, check to ensure the mounting buttons are fully seated in the slots.
NOTE: A padlock may be installed through the hole in the latching flag for additional security.
REMOVE THE DISPLAY
To remove the display from the mount, do the following:
1.Disconnect all power/audio/video cables.
2.Lower the latching flag to unlock the display (refer to Figure 9).
3.With the aid of another person, lift the display up and out of the teardrop slots in the mount to remove the display.
Display
PLP
PSB
Figure 8. Install the Display
Lock
Unlock
Teardrop Slot
Latching
Flag
Figure 9. Raise Latching Flag to Lock
7
