Chief Manufacturing PLP Series Tilt Adjustment, Cable Connection, Tilt Display Down

Installation Instructions PLP Series

TILT ADJUSTMENT

To tilt the display 0° to 15° down, do the following:

1.Manually tilt the display 0° to 15° down into the desired position.

2.If desired, tighten the nut (see Figure 10) to increase the amount of tension needed to hold the mount in the position set in Step 1.

NOTE:Tighten the nuts only to adjust the amount of tension needed to manually tilt and hold the mount in place. Do not over-tighten the nuts. Over-tightening the nuts may cause excessive wear and may damage your mount.

3.Repeat Steps 1 and 2 until the desired tension is obtained.

CABLE CONNECTION

To install or remove cables, do the following:

1.Manually tilt display down slightly (see Figure 10), and then pull bottom of display out (see Figure 11).

2.Lower center support bar to keep the display tilted up (see Figure 12).

3.Perform service. For example: Connect or disconnect the power/audio/video cables.

NOTE:The service position is not recommended as a final display position.

4.Raise the center support bar and reposition the display to desired position (if necessary, refer to “TILT ADJUSTMENT” procedure) after service is completed.

WARNING: Watch for pinch points. Do not put your fingers between moveable parts.

15°

0°

1. Adjust pitch

2. If necessary, tighten nut slightly to increase tension.

Figure 10. Tilt Display Down

1. Tilt display down (see Fig. 10)

2. Pull bottom out (See Fig. 11)

3. Lower support bar.

4. Perform service.

5. Return display to desired position.

0°

8°

Figure 11. Tilt Display Up (for service only)

	Tilt the display
Center	0° to 8° to connect
	or disconnect cables.
support bar

Figure 12. Cable Connection

8