Model PNR™ | Installation Instructions |
Mount (Hang) the PNR on Lag Bolts
Install Cover Plates and End Caps
NOTE: The cover plates and end caps have pressure fitting ends that lock in place with each other.
1.Install cover plate (20) over the top bracket. (See figure 5)
2.Install end cap (30) on the cover plate (20). (See figure 5)
3.Repeat steps 1 and 2 for the bottom mounting bracket. (See figure 5)
Figure 2
Use Lag Bolts and Washers to Fasten PNR to the Wall.
Figure 3
Adjust Height on the PNR
NOTE: Height adjustment range up to 1.08 inches.
To adjust the PNR height:
1.Check PNR for the desired height. If needed, use the adjustment wrench (40) to adjust the PNR height.
•Turn adjustment nut (see Figure 4) clockwise (CW) to lower the unit height, or
•Turn adjustment nut counterclockwise (CCW) to raise the unit height.
Adjustment Nut
Figure 4
End Caps (30) |
Cover Plate (20) |
Bottom Mounting Bracket |
Figure 5
6