Model PNR™ | Installation Instructions |
Management Channel
Figure 8
Bottom Cable
Management Channel
Figure 9
ADJUSTMENTS
TENSION ADJUSTMENTS
Vertical Tilt Tension Adjustment
1.With display mounted, check for desired vertical tilt tension.
2.Adjust the Centris SelectTM knob until desired vertical tilt tension is obtained. (See figure 10)
Centris SelectTM |
Adjustment Knob |
Figure 10
3.To lock the mount at the desired vertical tilt, tighten the vertical tilt lock screw. (See figure 11)
Vertical Tilt |
Lock Screw |
Figure 11
Lateral Tilt Tension Adjustment
CAUTION: Overtightening lateral adjustment will cause excessive wear and may distort adjustment components.
1.Using a 9/16” wrench (not provided), slightly tighten or loosen lateral tilt tension adjustment nut
(See figure 12).
2.Mount the display and check for desired tilt tension.
3.Repeat Steps 1 and 2 until desired tilt tension is obtained.
Rotational Tilt Tension Adjustment
1.If necessary, loosen or tighten bottom rotational tilt tension adjustment nut (See figure 12).
2.Mount the display and check for desired rotational tilt tension.
3.Repeat Steps 1 and 2 until desired rotational tilt tension is obtained.
8
