APPENDIX
AIR FILTERS CARE AND CLEANING
Air filters help prevent dust from accumulating on the optical elements inside the projector. To whatever extent the air filters become clogged with dust particles, the cooling fans’ effectiveness is reduced, which may result in an internal heat
How often the air filters should be cleaned really depends upon the environment in which the projector is being operated. As a rough guide, under a normally clean operating environment, the air filters should be cleaned approximately every 200 hours of use. However, if the projector is being operated in a somewhat dusty or smoky environment, the air filters should be cleaned more often; for consistently good projector operation and performance, timely cleaning of the air filters is a very important factor. When appropriate, clean the air filters following the steps below.
1 | Turn off the projector and unplug the AC power cord from an | ||||||
|
|
| AC outlet. | ||||
2 | Turn over projector and remove the air filters by pulling the | ||||||
|
|
| latches upward. | ||||
3 | Clean the air filters with a brush or rinse them softly. When | ||||||
|
|
| rinsing the air filters, dry them well. | ||||
4 | Replace the air filters properly. Make sure that the air filters | ||||||
|
|
| are fully inserted to the projector. | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| CAUTION |
| |
|
|
|
|
| Do not operate the projector with the air filters |
|
|
|
|
|
|
| removed. Dust may accumulate on the LCD Panel and |
|
|
|
|
|
|
| projection mirror degrading the picture quality. Do not |
|
|
|
|
|
|
| put anything into the air intake vents. It may result in |
|
|
|
|
|
|
| malfunction of the projector. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
RECOMMENDATION
A
B
AIR FILTERS
Pull up and remove.
NOTE: If the dust cannot be removed by cleaning, it is probably time to replace the air filters with new ones. Please consult your dealer.
Air Filter (A) Parts No.
We recommend avoiding dusty/smoky environments when operating the projector. Usage in these environments may cause a poor image quality.
When using the projector under dusty or smoky conditions, dust may accumulate on a lens, liquid crystal panels, or optical elements inside the projector. Such condition may degrade the quality of the projected image.
When the symptoms above are noticed, contact your authorized dealer or service station for proper cleaning.
CLEANING PROJECTION LENS
Follow these steps to clean the projection lens:
1 | Turn off the projector and unplug the AC power cord from an AC outlet. |
2 | Apply a |
| Abrasive cleaners, solvents ,or other harsh chemicals might scratch the surface of the lens. |
3
4
Gently wipe with the cleaning cloth over the projection lens.
When the projector is not in use, put the lens cap.
47
