Christie Digital Systems 38-DHD106-XX, 38-DSP104-XX, 38-DSP106-XX Stack Projectors. Always follow

Stacking Frame Installation Instructions

2. Stacking Multiple Projectors

Warnings

Christie stacking hardware is required to prevent the top projector from sliding off the stack. Failure to incorporate this hardware may cause injury or death.

The frame is designed to supportRELEASEDa maximum stacking capacity of three the Roadster/Mirage S+ and Roadster HD12K models to hoist the stack.

projectors. Always stack before hoisting.

The projectors can be stacked and hoisted in either an upright or inverted position. Do not mix orientations in a stack (i.e. inverted and upright).

	Never attempt to physically	carry		a stack		of projectors. Always follow the
	Hoisting Procedure, outlined on page 6.				Control		2006
	When hoisting a stack combining			oadster/Mirage S+ and Roadster HD12K
	models with any of the models listed in Table 1, use the hardware provided with
	OFFICIALLYSeptember
1.	Document					8,
	Place the first projector in the stack on a secu					table or cart.
	For upright stack: Place the projector to				positioned on the bottom of the stack
	on the table or cart. Ensure the adjusta				le f et are NOT retracted on the bottom
	projector. When installing the second and third projector in the stack the feet must
	be retracted. All projectors must		stacked in the same orientation.
	For inverted stack: Place the proj		ctor to		positioned on the bottom of the stack
	on the table or cart. Ensure the adjustable feet ARE retracted. Repeat this step when
	installing a second and third	rojector. All projectors must be stacked in the same
	orientation.

2. Turn each stacking leg until at least 1” of thread is visible.

For upright position: Extend the legs of the projector on the top of the stack.

For inverted position: Extend the legs of the projector on the bottom of the stack.

This clearance accommodates the up-or-down movement for image alignment.

Repeat Step 2 when installing a third projector.

IMPORTANT: Ensure all stacking legs are extended equally by at least 1”.

013-100342-01 (Rev.1) (08/06) 4 of 13 pages