Getting Started
Conduct Length Measurement You can conduct length measurement by using transmissive
sensor (default setting) for gap label roll or reflective sensor for
I-Mark media roll.
Please refer to the Programming Reference for changing
the sensor from transmissve to reflective, if the I-Mark media
roll is used.
(1) Open the media compartment cover, the LED1 and LED3
will light up orange and green respectively, and then start
flashing after10 seconds.
(2) Load the media roll.
(3) Press the FEED button and release it.
(4) Close the media compartment cover, the LED3 flashes
green 3 times. The MP3200(BT) will feed four labels to
execute length measurement. After the length measurement
is completed, the MP3200(BT) will be ready in the next
printing position and the LED1 of MP3200(BT) will flash
green(red) at 2 seconds intervals.
(5) The MP3200(BT) is ready for page mode operation.
If the length measurement is failed or executed without setting
the correct media roll, the MP3200(BT) will issue a paper jam
error. Please conduct length measurement once again. On
condition that the length measurement is done successfully, the
value will be stored into the flash memory. When you load the
same media roll next time, the MP3200(BT) will perform
top-of-form by feeding one label or one measured length of the
receipt paper right after you close the media compartment cover
in power-on state.
The MP3200(BT) will also feed one label or one measured
length of the receipt paper while pressing the FEED button.
However, if you load a different media roll, you will have to
re-conduct length measurement.
Revert to Standard Mode
The printing mode will be switched to page mode after the length
measurement is completed. If you would like to revert it to
standard mode, please follow the steps indicated below :
(1) Open the media compartment cover, the LED1 and LED3
will light up orange and green respectively, and then start
flashing after10 seconds.
9
MP3200 User’s Guide